Download LEDA54CW - Velleman

LEDA54CW
6. Powering your PIR Light
Refer to the illustrations on pages 3, 4 and 5 of this manual.
6.1 Inserting the Batteries
Insert the batteries (not included) according to the illustrations below:
1.
2.
3.
Open both battery compartments [1a].
Place the batteries in the battery compartments. Mind the polarity
[1b].
Close both battery compartments [1c].
6.2 Recharging the Batteries
Recharge the batteries using a compatible phone charger (not included) or a
computer (not included). Connect using a compatible connection cable (not
included) [2]. Make sure to use rechargeable batteries.
7. Installation
7.1 Installation with Double-Sided Tape
1.
2.
Make sure the installation surface is dry, smooth and grease-free.
Clean with a cloth and dry if necessary. Tear off the protective film
from both pieces of tape and apply them on the mounting bracket
[3a].
Tear off the protective film from both pieces of tape and glue the
mounting bracket onto the mounting surface [3b].
7.2 Installation on a Wooden Board
1.
2.
3.
Choose your installation spot.
Place the mounting bracket against the board and drill the included
KA3x10mm screws into the board [4a].
Fix the light to the bracket [4b].
7.3 Installation on a Concrete Wall
1.
2.
3.
Choose your installation spot.
Drill two holes using a masonry drill bit (not included) and insert a
nylon plug in each hole. Refer to the illustration below for the
measurements [4c].
Fix the light to the bracket using the included KA3x18mm screws
[4b].
V. 03 – 07/09/2015
8
©Velleman nv