Download 1 informazioni generali

1
2.8 Clock
This function describes the correct operation/
display of the current time function.
This function is always displayed in the format,
hh:mm, using digits 6-9 (fig. 12).
Fig. 12
The clock remains active even when the
microcontroller enters the low power phase
(sleep-mode).
The information is not stored in the memory.
GENERAL INFORMATION
Sequence displayed:
from 0:00 to 23:59 for mode
from 0:00 to 12:59 for mode
Am
from 1:00to 11:59 for mode
Pm
0-24
0-12
0-12
Clock accuracy: ± 2.5 sec/day
Note: In the absence of mains power, the TIME value is irretrievably
lost.
2.8.1 Clock adjustment
The clock can only be adjusted when the
vehicle is stopped, keeping the button pressed
for approx. 5 sec in correspondence with the
standby function.
Fig. 13
Adjustment is possible once only the segments
relating to the clock are active, while all the
other segments are switched off (figure 13).
is possible
to change
thedisplayed
hour first and
then
the minutes depending on what number is Itselected
(which
will be
flashing
with f=1Hz, Duty=50%).
A short press of the button will allow a unit increase of the parameter selected, while a
long press of the button will allow for a switch from time adjustment to that of minutes
and then to exit adjustment mode.
The clock will be displayed in the format 0-24 if the unit of measurement selected is
Km/h, while it will be displayed in format 0-12 if the unit of measurement selected is mph.
GB
102