Download SCRUBBER-DRYER

SERVICE MANUAL
SWEEPING SYSTEM
RECOVERY WATER TANK AND VACUUM GRID WITH FLOAT CLEANING
1.
2.
3.
4.
5.
6.
Drive the machine to the appointed disposal area.
Turn the ignition key (12) to "0" position.
Lift the cover (45).
Clean and wash with clean water the cover (45), the tank (58) and the grid (48) of the vacuum automatic
shut-off.
Drain the water in the tank through the hose (22).
If necessary, release the retainers (A) and open the grid (B), recover the float (C), clean all the components,
and then reinstall them.
Check the integrity of the tank cover gasket (D).
NOTE
The gasket (D) creates vacuum in the tank, which is necessary for the vacuuming of recovery
water.
7.
8.
If necessary replace the gasket (D) after removing it from its housing (E). When assembling the new gasket,
install its joint (F) in the (central rear) area as shown in the figure.
Check that the gasket (G) bearing surface (D) is integral and adequate for the gasket itself.
Close the cover (H).
S301335
36
909 6424 000(1)2005-11