Download Quick Clean 1500 (Nobles All Surface Cleaner)
Transcript
OPERATION 8. While cleaning, periodically check for excessive foam in recovery tank. Pour a recommended foam control solution into the recovery tank if excessive foam appears. This will prevent vacuum motor damage (Figure 27). FIG. 28 3. Rinse out recovery tank after each use to prevent foul odor. Be careful not to spray water into float shut–off screen. 4. Replace drain hose plug tightly after draining. FIG. 27 ATTENTION: Excessive foam buildup will not activate the float shut-off screen. ELEVATED DRAINING 9. If squeegee begins to trail water while operating, recovery tank must be drained (See DRAINING TANKS). Use the convenient pump–out procedure if drain site exceeds 13 inches (33 cm.) in height. 10. When finished cleaning, turn machine off and wipe off blower and vacuum hoses. Store hoses on machine. 1. Attach gray blower hose to blower hose connector and to vacuum hose connector (Figure 29). 11. Push machine to drain sit and empty recovery tank. NOTE: After cleaning one area, it is best to empty the recovery tank before proceeding to the next area to be cleaned. DRAINING TANKS When finished cleaning, the recovery tank should be drained and cleaned. If you have left–over rinse solution, it can remain in solution tank for next use. Drain solution tank when storing machine for extended periods or when transporting machine. FOR SAFETY: When servicing machine, unplug cord from wall outlet. FIG. 29 ATTENTION: Make sure recovery tank lid is secure before activating blower. 2. Remove drain hose knob, direct hose into elevated drain site and activate blower (Figure 30). DRAINING RECOVERY TANK Recovery tank must be emptied prior to refilling solution tank. 1. Turn machine off, unplug power cord and push machine to drain site. 2. Remove drain hose from holder. Turn drain hose knob counter–clockwise approximately three full turns and pull out plug to drain. Keep hose above water level when removing plug (Figure 28). 12 Home Find... FIG. 30 Go To.. Quick Clean 1500 (03–00)