Download OperatOr`s Manual

Transcript
4.
5.
Balance the deck by using a wrench to turn the adjustment
gear (found immediately behind the hex cap screw just
loosened) clockwise/up or counterclockwise/down.
The deck is properly balanced when both blade tip
measurements taken earlier are equal.
Retighten the hex cap screw on the left deck hanger
bracket when proper adjustment is achieved.
Seat Adjustment
Refer to the Set-Up and Assembly section of this manual for seat
adjustment instructions.
Parking Brake Adjustment
WARNING: Never attempt to adjust the brakes
while the engine is running. Always disengage PTO,
move shift lever into neutral position, stop engine
and remove key to prevent unintended starting.
If the tractor does not come to a complete stop when the brake
pedal is completely depressed, or if the tractor’s rear wheels
can roll with the parking brake applied, the brake is in need of
adjustment. See an authorized Troybilt Service Dealer to have
your brakes properly adjusted.
Maintenance Schedule
Before
Each use
Clean Hood/Dash Louvers
Check Engine Oil Level
Check Air Filter for Dirty, Loose or Damaged Parts
P
P
Every
10 Hours
Every
25 Hours
Every
50 Hours
P
P
Clean and Re-oil Air Filter’s Foam Pre-cleaner
P
P
Replace Air Filter Element
Change Engine Oil and Replace Oil Filter
P
(if Equipped)
P
P
P
Lube Front Axles and Rims
Clean Engine Cooling Fins
Lube Pedal Pivot Points
Check Spark Plug Condition & Gap
Replace Fuel Filter
Prior
to Storing
P
(if Equipped)
Clean Battery Terminals
Every
100 Hours
P
P
P
P
P
P
P
P
IMPORTANT: It is important to consult the specific engine operator’s manual included with this machine for detailed engine
maintenance procedures and intervals.
Section 6 — Maintenance & Adjustments
21