Download OperatOr`s Manual - Troy-Bilt

4
Controls & Features
On/Off Switch
Attachment Control Safety Lock
Attachment Control Lever
Handle Adjustment Knob
Drive Control Lever
Cold Weather/Warm
Weather Control
Fuel Cap
Oil Fill Cap
Recoil Starter
Primer
Key
Kickstand
Choke
Figure 4-1
Attachment Control Lever
Kickstand
The attachment control lever is for deploying power to the
various available attachments. See also Figure 4-2.
The kickstand is utilized to hold the FLEX™ Power Base in an
upright and parked position when there is NO attachment
present. It also locks the attachment to the power base (when in
“Up” position) and unlocks the attachment when placed in the
down position.
Handle Adjustment Knobs
Utilize these two knobs to adjust the height and position of the
FLEX™ Power Base’s handle assembly. Refer to Installing and
Adjusting the Handle in the Assembly and Setup Section of this
manual for specific instructions regarding adjusting the handle.
Cold Weather/Warm Weather Control
This control is utilized throughout the year. Turn the control to
Winter for Winter operation (below 320F), and Summer (above
320F) for Summer operation.
12
Recoil Starter
The recoil starter employs a starter rope and handle used to pullstart the engine.