Download OPERATORLS MANUAL
Transcript
7 Engine Maintenance WARNING! To prevent accidental start-up, shut off the engine and remove the ignition key before performing any type of engine maintenance. Periodic inspection and adjustment of the engine is essential if high level performance is to be maintained. Regular maintenance will also ensure a long service life. The required service intervals and the type of maintenance to be performed are described in the table below. Follow the hourly or calendar intervals, whichever occur first. More frequent service is required when operating in adverse conditions. Maintenance Schedule Tasks First 5 Hrs. Each Use or Every 5 Hrs. Every Season or 25 Hrs. Every Season or 50 Hrs. Every Season or 100 Hrs. Service Dates Check engine oil Change engine oil Check spark plug Service spark plug Clean exhaust area Changing Engine Oil 6. NOTE: Check the oil level before each use and after every five hours of operation to be sure correct oil level is maintained. Refer to Checking Oil Level in the Operation section Refill with the recommended oil and check the oil level, refer to Operation section for instructions. 7. Reinstall the oil filler cap/dipstick securely. 1. Drain fuel from tank by running engine until the fuel tank is empty. Be sure fuel fill cap is secure. 2. Place suitable oil collection container under oil drain plug. 3. Remove oil drain plug, Figure 7-1. CAUTION: Thoroughly wash your hands with soap and water as soon as possible after handling used oil. NOTE: Please dispose of used motor oil in a manner that is friendly to the environment. Take it to a recyling center or other collection center. Oil Recommendations When adding oil to the engine, refer to viscosity chart below. Engine oil capacity is 600 ml (approx. 20 oz.). Do not over-fill. Use a 4-stroke, or an equivalent high detergent, premium quality motor oil certified to meet or exceed U.S. automobile manufacturer’s requirements for service classification SG, SF. Motor oils classified SG, SF will show this designation on the container. Synthetic 0W-30 5W-30 Oil Drain -40º -20º 0º 20º 40º Oil Plug -30º -20º -10º 0º Figure 7-1 4. Tip engine to drain oil into the container. Used oil must be disposed of at a proper collection center. 5. Reinstall the drain plug and tighten it securely. caution: DO NOT use nondetergent oil or 2-stroke engine oil. It could shorten the engine’s service life. 19
This document in other languages
- español: Troy-Bilt 31AM63P3711