Download STIHL HTA 85

English
Chain Scabbard
Cutting Attachment
Mounting the Bar and Chain
A cutting attachment consists of the saw
chain, guide bar and chain sprocket.
Removing the chain sprocket cover
a
–
–
3
The pitch (t) of the saw chain (1),
chain sprocket and the nose
sprocket of the Rollomatic guide bar
must match.
The scope of supply includes a bar
scabbard that matches the cutting
attachment.
If guide bars of different lengths are
mounted to the pole pruner, always use
a chain scabbard of the correct length
which covers the complete guide bar.
N
The length of the matching guide bars is
marked on the side of the chain
scabbard.
Unscrew the nut and remove the
cover.
1
The drive link gauge (2) of the saw
chain (1) must match the groove
width of the guide bar (3).
If non-matching components are used,
the cutting attachment may be damaged
beyond repair after a short period of
operation.
54
0022BA011 AS
001BA248 KN
2
2
N
0022BA012 AS
1
001BA244 KN
The cutting attachment that comes
standard is designed to exactly match
the pole pruner.
Turn the screw (1)
counterclockwise until the tensioner
slide (2) butts against the left end of
the housing slot, then back it off 5
full turns.
HTA 85