Download Instruction Manual

Transcript
IMPORTANT PARTS
TROUBLESHOOTING GUIDE
If you have difficulty operating your Aeroneb® Go,
check the following points:
Medication Cup Cap
Ventilation Holes
Mouthpiece
Medication Cup
(with OnQ Aerosol
Generator)
PROBLEM
CHECK
No visible aerosol Check that the
when using
batteries are inserted
batteries
correctly.
Nebulizer Body
Check to see if the low
battery power light is
flashing.
Battery Powered Controller
- Model 7010 with detachable power cord
UNIT ASSEMBLY AND USAGE
NOTE: Clean all parts of your Aeroneb® Go Nebulizer
(as described in this instruction manual) before first use,
after each use, or after extended storage.
PRIOR TO ASSEMBLY:
Check all parts for visible damage. Replace any damaged parts
before you use the Aeroneb® Go. In the case of missing parts,
malfunction or damage, contact your local Aeroneb® Go
representative or evo Medical Solutions.
IMPORTANT NOTICE
Replace the batteries or use
the AC Powered Controller.
Check that the Battery Connect the cable
Powered Controller
properly to the nebulizer
cable is connected
and the Battery Powered
properly to the nebulizer Controller. (Refer to page 7).
and to the Control
Module.
AC/DC Controller
- Model 7030 with attached power cord
REMEDY
Using the markings under
each battery location, place
each battery in the Battery
Powered Controller
housing. Match (+) and (-).
No visible aerosol
when using AC
Powered
Controller.
Check that the AC
Powered Controller is
plugged correctly into
a working AC outlet.
Insert the plug into a working outlet and verify that the
green light on the controller
is lit (Refer to page 9).
Check that the AC
Connect the cable
Powered Controller cable properly to the nebulizer
is connected properly to and the AC Powered
the Aeroneb Go
Controller. (Refer to page 9).
Nebulizer Unit.
No visible aerosol Check that there is
when power
medication in the
source is
Medication Cup.
functioning
Fill the Medication Cup with
prescribed medication.
Inspect Medication Cup Clean the Aeroneb Go.
to see if it is dirty.
Refer to page 10.
If above remedies do not work, call your local supplier.
Before you begin, run the Medication Cup under hot water,
then tap the generator slightly.
5
14