Download STRIKE 882 Quick Reference Guide Rev. 7 Multi

STRIKE™ 882 QRG
EN
AC Power This product has an auto-ranging power supply that can work with an input
voltage range of 100–240 VAC, 50/60 Hz.
To eliminate unnecessary wear and improve its lifespan, during
periods of non-use completely disconnect the product from power via
breaker or by unplugging it.
Power Linking You can link up to 3 STRIKE™ 882 products at 120 V, 5 products at 208 V,
or 6 products at 230 V. Never exceed this number. Power linking cords can be
purchased separately.
AC Plug
Connection
AC Live
AC Neutral
AC Ground
Replacing the 1.
Fuse 2.
3.
4.
Wire (U.S.)
Black
White
Green/Yellow
Wire (Europe)
Brown
Blue
Green/Yellow
Screw Color
Yellow/Brass
Silver
Green
Disconnect this product from power.
Using a flat-head screwdriver, unscrew the fuse holder cap from the
housing.
Remove blown fuse and replace with a good fuse of the same type
and rating.
Screw the fuse holder cap back in place and reconnect power.
DMX Linking The STRIKE™ 882 will work with a DMX controller using a regular DMX
serial
connection.
A
DMX
www.chauvetprofessional.com.
Primer
is
available
from
DMX Connection The STRIKE™ 882 uses a regular DMX data connection for its DMX
personalities: 1 Ch, 5 Ch, 6 Ch, and 10 Ch. See the User Manual to connect
and configure for DMX operation.
Master/Slave The STRIKE™ 882 uses the DMX data connection for its Master/Slave
Connection mode. See the User Manual to connect and configure for master/slave
operation.
3