Download LC-171

Transcript
6
Detector Installation
Important! Prior to installation, read both “Operation” and “Selecting the mounting
EN
location” sections carefully.
1. Install the detector in such manner that the intruder
2. The detector is to be installed at height of 0.8 to 1.5
is most likely to cross the detection area from side to
meter (2.6 to 4.9 ft.), ideally 1.2m (4 ft.)
side.
3. Make sure to attach the metal bracket to a leveled
4. Rotating the detection beam may be required for
straight and firm wall, leaving 15cm (5.9 inches) from
guarding a side window opening while the detector is
the top and 15cm from both sides, for easy installation
installed facing another direction.
and maintenance.
5. Open the detector unwinding the bottom screw.
6. Release the rear metal bracket by unwinding
internal bottom screw.
7. Release the detector body from the metal bracket
8. Attach the rear bracket to the wall or a pole using
by pulling the detector out and up.
mounting screws or metal bands.
7