Download operation - Husqvarna

UNASSEMBLED PARTS
Keys
Slope Sheet
Battery
(1) Oil Drain Tube
(2) Hex Bolts
Key(s)
(1) Quick
Connect
(2) Nut Keps
ASSEMBLY
Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are listed.
(1) 1/2" wrench
Tire pressure gauge
(2) 7/16" wrenches
Utility knife
Pliers
When right or left hand is mentioned in this manual, it means
when you are in the operating position (seated behind the
steering wheel).
LABEL
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
•
•
•
Fig. 1
Remove all accessible loose parts and parts cartons
from carton.
Remove end panels and lay side panels flat.
Check for any additional loose parts or cartons and
remove.
ADJUST SEAT (See Fig. 2)
•
•
BEFORE REMOVING TRACTOR FROM
SKID
•
Sit in seat.
Lift up adjustment lever (A) and slide seat until a comfortable position is reached which allows you to press
clutch/brake pedal all the way down.
Release lever to lock seat in position.
CHECK BATTERY (See Fig. 1)
• Lift seat to raised position.
NOTE: If this battery is put into service after month and
year indicated on label (label is located between terminals)
charge battery for minimum of one hour at 6-10 amps. (See
"BATTERY" in the Maintenance section of this manual for
charging instructions.)
• For battery and battery cable installation see "REPLACING BATTERY" in the Service and Adjustments section
in this manual.
A
Fig. 2
5