Download INSTALLATION MANUAL BEFORE INSTALLATION
Transcript
MESURES D'INSTALLATION Le robinet et les drainages du bidet doivent être achetés séparément. La dimension de l'installation et la performance hydraulique répondent ou dépassent tous les standards ANSI/ASME A112.19.2 et les requis CAN/CSA B45. 1 INSTALLATION PREPARATION Turn-off water supply and if necessary remove the old bidet. Install or relocate the supply tubing and waste pipe to the specified rough-in dimension. Set the bidet on the desired installation location and mark the position of the mounting holes. Remove the bidet and drill 3/16” holes in the center of the marked location. Thread the floor bolts (included) into the mounting holes. Use anchors as necessary. Place the bidet over the mounting bolts so that both of the bolts extend through the bidet mount holes behind the skirt. ENGLISH 2 INSTALLATION OF THE BIDET Install washer and nuts. Hand-tighten nuts first, then tighten additional 1/2 turn with wrench. ! DO NOT OVERTIGHTEN the screws. May damage the products and cause personal injury and/or property damage FRANÇAIS Warning Fig. 1 BT930 - Back View 3 10 FINISHING THE INSTALLATION Install the faucets and drain per manufacturer’s instructions. Turn-on the water supply and check entire installation for leaks. 3