Download Models / Modèles / Modelos

Description / Typical Installation
PENTEK INTELLIDRIVE Includes:
•
•
•
•
•
PENTEK INTELLIDRIVETM
Pressure Transducer
10’ Pressure Transducer Cable
Quick Start Guide
Owner’s Manual
4
Table 1: Model Number Structure
PID-1- 10A1-1:
PID
–
1
–
10A1
–
1
Product Family
PID = Pentek IntelliDrive
The PENTEK INTELLIDRIVE is specifically designed to
operate 4” submersible pumps in water well applications. Each drive is rated for horsepower and amp
draw. Any use of the drive outside of its intended use
and design parameters will void the warranty.
Transducer
The drive uses a 4-20mA, 0-100PSI pressure transducer to
control the speed of the motor.
The transducer senses pressure in the pipe and converts it
to an electrical signal which it sends to the drive. The drive
processes the signal in the PID (Proportional, Integration,
Derivative) control. When operating in PID mode the drive
increases and decreases the speed of the pump motor as
needed to maintain constant pressure in the system.
Fan
The PENTEK INTELLIDRIVE has a thermostatically controlled internal fan. The fan may not operate under normal
operating conditions. It will automatically start when necessary to cool the drive.
Voltage Rating:
1 = 190–265 Volt 1-Phase In,
3-Phase Out
6 = 190–265 Volt 1-Phase In,
1-Phase Out
Max Amp Rating:
4A7 = 4.7 Amps
7A6 = 7.6 Amps
9A7 = 9.7 Amps
10A1 = 10.1 Amps
12A2 = 12.2 Amps
Enclosure Type:
1 = NEMA 1 (Indoor Rated)
3 = NEMA 3R (Outdoor Rated)
Keypad
The Keypad programs the drive, monitors the status of the
pump, and views faults if they occur. Each button has a
unique function (see Page 5). The LCD display shows a
text display of the status of the drive’s operation. Other
LEDs light up to indicate when certain buttons are pressed
or certain events occur.
Transducer; install at
least one foot away from
pipe fittings on each side.
Grnd
6004 0509
Figure 1: Overall Layout – Typical installation