Download Installation step 3

Contents
ENGLISH
FRANÇAIS
About CADWS Heating cable
2
A propos du câble chauffant CADWS
Before you start
3
Avant de commencer
23-24
Do’s and Don’ts
4-5
A faire et à ne pas faire
25-26
Electrical considerations
6-7
Considérations électriques
27-28
Wiring diagrams
Subfloor preparations
8
9-10
Schéma de câblage
Préparation du sous-plancher
23
29
30-31
Installation layouts
11
Plans d’installation
32
Installing multiple heaters
12
Installation de plusieurs câbles
33
Installation steps
13-20
Etapes d’installation
34-41
Spacing guides
15-16
Guides d’espacement
36-37
Warranty / Terms and Conditions
21
Warranty / Terms and Conditions
42
Warranty registration form
22
Warranty registration form
43
About CADWS heating cable
The CADWS heating cables consist of a fixed length of heating cable terminated at one end with
2.7 meters (9') of unheated lead (cold tail). If necessary, the cold tail can be extended if a CSAapproved wire and connector box suitable for the purpose is used (e.g. waterproof if going into
the floor, etc.). If the unheated lead is shortened, a minimum of 30.4cm (12") of lead must be left
before the joint. This must be carried out by a qualified electrician in accordance with local and
state laws and guidelines.
The core and ground braid are factory joined in a water resistant joint assembly to each supply
conductor and ground conductor of the unheated lead.
The Warmup® Undertile™ Heater is CSA listed (File No. 237753).
Application : Usage “W “ embedded floor warming application.
Inspect the entire heater for damage, this includes the factory made joint and end termination.
The joint and end termination cannot be altered or remade if damaged. If any parts are damaged,
contact the technical helpline 1-888-5-WARMUP.
2