Download instructions d`installation

SETTING
THE BURNER
MINIMUM
When switching from one type of gas to another, the minimum flow rate must also be
correct: the flame should not go out even when passing suddenly from maximum to
minimum flame.
To regulate the flame follow the instructions below:
Rapid
-
and triple ring burners
Light the burner
Set the gas valve to LO position
Remove the knob
With a thin screwdriver pass by the hole of microswitch
adjustment is correct (fig. 2.7).
o
o
and turn the screw F until
Fig. 2.7
Inside crown of DUAL burner
-
Light the DUAL burner
Set the gas valve toS_ position
Remove the knob
Using a screwdriver turn the screw H until the correct setting is obtained (fig. 2.8).
H
G
Outside crowns of DUAL burner
- Light the DUAL burner
Set the gas valve to
position
- Remove the knob
- Using a screwdriver turn the screw G until the correct setting is obtained (fig. 2.8).
For LP/PROPANE
gas, tighten the adjustment
screws completely.
Fig. 2.8
21