Download 411864

Transcript
Step 17
å
å
Carefully stand your unit upright.
å
NOTE: You may need to loosen the mounting screw and
adjusting screw to slide them part way out of the slot. Retighten
the screw before you mount the HINGE to the MOLDING.
å
Fasten a KNOB (HH) to the DOOR (H). Use a GOLD 1"
MACHINE SCREW (PP).
å
Peel two FELT DISC from the FELT DISC CARD (II) and
stick them on the DOOR (H) where they come in contact
with the UPRIGHT (C).
å
Repeat this step for the other DOOR (H).
Fasten a DOOR (H) to the RIGHT HINGE MOLDING (U).
Use the screws in the HINGES. See the next step for door
adjustments.
Adjusting screw
Mounting screw
HH
U
H
C
II
PP
GOLD 1" MACHINE SCREW
(2 used in this step)
www.sauder.com/services
411864
Page 21