Download Notice d`instructions
Transcript
Connexion d'un moteur brushed: Le contrôleur reconnaît, dès sa mise sous tension, le type de câblage du moteur (excepté en configuration moteur 4). dépendant de MODE 0-8 bref bip Signal LED rou ja rouge LED allumera jaune LED allumera rou ja ... ... rou ja rou ja rouge LED clignote, jaune LED allumera rou ja rou ja rou ja rou ja rou ja rot rouge LED clignote 6x, jaune LED allumera (Configuration moteur 2) Connexion d'un moteur brushed pour les fonctions marche avant/moteur coupé/(freins) (Doublage de la tension permis) ventilateur: 5 - 6 V connexion IDA-System, palpeurs hall - Moteur M - LED jaune touche SET LED rouge noir orange -jaune + + fil de récepteur accu ++ bleu rouge (Configuration moteur 3) Connexion d'un moteur brushed pour les fonctions marche avant/moteur coupé/(freins)/marche arrière. Attention ! Tension maximale d'alimentation maximale 7,4V. Seule la moitié de la tension est ici permise ! Utilisez les modes 4 ou 5. ventilateur: 5 - 6 V connexion IDA-System, palpeurs hall jaune + M - Moteur - LED jaune touche SET LED rouge noir orange + fil de récepteur accu + bleu rouge (Configuration moteur 4) Connexion d'un moteur brushed pour les fonctions marche avant/moteur coupé/(freins)/marche arrière. Attention ! Tension d'alimentation maximale 7,4V ! Seuls les 2/3 de la tension sont ici permis. Utilisez les modes 4 ou 5 ! « Réservé » (RESERVED) doit être sélectionné sur le programme 64, car sinon le contrôleur reconnaîtra un moteur de type brushless ! ventilateur: 5 - 6 V connexion IDA-System, palpeurs hall 6 + M - Moteur - LED jaune touche SET LED rouge noir orange jaune accu + bleu rouge + fil de récepteur