Download Operating Instructions Manuel d`utilisation

Beard trimmings may clog the
drain at the bottom of the
cleaning tray.
In this case, you cannot clean
or dry the shaver.
Push the beard trimmings
down through the drain with a
tooth pick etc.
4. Slide the slide panels  and remove them.
5. Remove the housing clips .
6. Remove the six housing screws .
7. Remove the housing .
8. Lift the batteries  and remove them.
English
When the water does not drain from the cleaning
tray
Removing the built-in rechargeable battery
ATTENTION:
A Nickel-Cadmium battery that is recyclable powers the product
you have purchased. At the end of its useful life, under various
state and local laws, it is illegal to dispose of this battery into your
municipal waste stream. Please call 1-800-8-BATTERY for
information on how to recycle this battery.
Remove the built-in rechargeable battery
before disposing of the shaver. Do not
dismantle or replace the battery so that
you can use the shaver again. This could
cause fire or an electric shock. Replace it
at an authorized service center.
1. Disconnect the power cord from the
shaver when removing the battery.
2. Remove the bottom cover screw .
3. Remove the bottom cover .
FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLLFREE (IN USA ONLY) NATIONAL ACCESSORY PURCHASE
HOT LINE AT 1-800-332-5368.
IN CANADA, CONTACT PANASONIC CANADA INC. AT THE
ADDRESS OR TELEPHONE NUMBER ON THE BACK PAGE.
11
ES7056.indb
11
2006/06/30
11:10:31