Download E - YouSoSoft

MANUEL 44 2010:MANUEL quadri2006 01/04/10 16:35 Page17
5 CLEANING FILTER CARTRIDGES
To be performed after each use.
• Stop the robot before taking it out of the pool:
. Bring it in to the edge by gently pulling on the electric cable, then take hold of the robot by
its handle only.
17
. Slowly raise the robot so that it is emptied of all the water inside it before placing it on the
ground.
Reminder:
The cable is equipped with a float that must in no event be used as a handle
to lift the robot as this could damage your appliance’s electrical harness.
• It is easy to gain access to the filters through the two flexible doors on the cover.
• Raise the filter cartridge
cover then empty out the waste
and rinse with clean or slightly
soapy water.
Always leave the
filters to dry
outside the robot.
H
Craftiness to facilitate
the implementation of
cassettes : Position
the big side always
towards the outside
(See fig. opposite)
• Raise the door and
turn the latch before
removing the filter
cartridge.
Caution:
Make certain that the bottom of the robot is free from
dirt before replacing the filter cartridges.
Make certain of direction of assembly. The suction inlets
under the cover must fit into the openings located on
the bottom of the robot. (figure opposite)
After installation, turn the latch to lock the filter cartridge
in place.
GB