Download TIPPMANN®
Transcript
on page 14 and take your air/CO2 cylinder to a “C5” Certified Airsmith for inspection or contact the cylinder manufacturer. 3. Loading the Hopper and Cyclone Feed System The barrel blocking device must be installed (see page 4) and the Selector Switch in Safe mode (see page 6). a. Make sure that the Cyclone Feed System Cyclone Feed System (CFS) housing is clean and free of debris. Manual Advance Lever Make sure the Cyclone’s internal arms turn freely when the Manual Advance Lever is pushed (see Figure 4). b. Make sure that the Hopper is clean and free of sharp edges or debris. This keeps the paintballs from breaking prematurely, and allows the marker to feed paintballs to the marker’s chamber smoothly. 4: Manual Advance Lever for the c. Install the Hopper (21) neck into the CFS Figure Cyclone Feed System housing (68), aligning the hopper neck tab to fit into the cutout in the CFS housing. Turn counterclockwise to secure. d. With the barrel blocking device installed (page 4), and the Selector Switch in Safe mode (page 6), you are now ready to load your hopper with .68 caliber paintballs. Do not force excessive numbers of paintballs into the hopper. e. Push the Manual Advance Lever once to chamber a paintball. Only remove the barrel blocking device and change the Selector Switch to a Fire Mode when you are ready to fire the marker in a safe direction. 4. Firing the Marker Point the marker in a safe direction. Remove the barrel blocking device from the marker. Move the Selector Switch from Safe mode to a desired firing position (F or FA (Electro-pneumatic model only)). Pull the trigger to fire the marker. Velocity Adjuster Velocity Adjustment Each time you play paintball, check the velocity of your paintball marker with a chronograph (an instrument for measuring velocity) prior to playing Figure 5: Velocity Adjuster Location paintball. Verify that the marker’s velocity is set below 300 feet per second (or less if required by the playing field). To adjust the marker’s velocity, use the included ⅛” Allen wrench in the holes of the velocity adjuster. The velocity adjuster is located on the right side of the Upper Receiver, as shown in Figure 5. As shown in Figure 6, reduce the velocity by turning the velocity adjuster upward. To increase the velocity, turn the velocity adjuster downward. Figure 6: Velocity Adjuster Detail 9 E N G L I S H