Download Manuel d`utilisation

EN
Binding
1. Insert the bind plug into the BIND port on the receiver.
2. Connect a fully charged battery to any open port on the receiver. The battery
voltage must be at least 6V (max. 9.6V). The orange LED in the receiver
flashes continuously, indicating that the receiver is in bind mode.
If the vehicle uses an electronic speed control (ESC):
•Connect the ESC to the throttle channel on the receiver.
•Connect a fully charged vehicle battery to the ESC, then power
on the ESC.
3. With the throttle channel in the desired preset failsafe position (Normally full
brake), place your transmitter in bind mode. Hold the failsafe position until
the binding process is complete.
4. The orange LED on the receiver turns solid, indicating that the bind process
is complete.
CAUTION: When the bind process is complete, the throttle and steering
channels are active. Keep hands and loose objects away from all
spinning parts on the vehicle.
5. Remove the bind plug from the receiver and store it in a convenient place.
Failure to remove the bind plug will result in the receiver entering bind
mode the next time you power on the receiver.
The only time it is necessary to rebind is if different failsafe positions are
desired e.g., servo travel has been reversed after the initial bind, or if you want
to use the receiver with a different model memory.
2.4GHz Troubleshooting Guide
Problem
Possible Cause
Solution
The system will
not connect
Your transmitter and
receiver are too close
together
Move transmitter 8 to 12
feet away from receiver
You are near metal objects
Move to an area with less
metal
The receiver is bound to a
different model memory
Make sure the correct
model memory is active in
your transmitter
Your transmitter was
placed into bind mode and
is no longer bound to your
receiver
Rebind your transmitter
and receiver