Download Auping Basic Type 333B - Auping Service Manual

6511000 GBA 333B.qxd
30-05-2005
08:39
Pagina GB 6
4. Use
4.2 Adjusting the power of the
gas spring
The power with which the back
section of the mesh base is raised
and lowered is adjustable. There are
three settings:
1. light (top hole): if you select the
‘light’ setting, the back section is
easiest to push flat.
2. normal (middle hole): standard
setting.
3. heavy (bottom hole): if you select
‘heavy’, the back section comes
up with extra force.
Adjusting the spring tension
1. Lift the back section half way up.
5. Press the connecting pin through
the lifting arm and the eyelet of
the gas spring (take care with
the plastic bearing bush in the
eyelet of the gas spring).
fig. 5
6. Tighten the plastic notched nut
(see fig. 5).
4.3 Moving the control ball
The control ball for your mesh base
is on the right, but it can easily be
moved to the left.
fig. 4
2. Unscrew the plastic notched nut
(see fig. 4).
3. Attention: support the back
section and remove the
connecting pin (take care with
the plastic bearing bush in the
eyelet of the gas spring).
4. Place the eyelet of the gas
spring in the required position.
The top hole towards the mesh
gives the smallest adjustment.
GB 6
A
C
B
fig. 6
1. Untie the knot A from the cord B
and remove the ball C (see
fig. 6).