Download Calys 1000/1200/1500

Transcript
CALYS 1000/1200 OPERATION & APPLICATIONS
CALYS 1500
Alarm status
Battery low
:
Reading In
:
Reading InP
:
Reading Out
: ALARM
Overload In
:
Overload InP :
Overload Out :
Press any < > or < > key to recall the previous o the following Alarm Status pages.
Alarm status
Calibr. data : NONE
Ref. Junct. In :
Ref. Junct. Out :
Calys
1000
Alarm status
Calibr. data : NONE
Ref. Junct. In :
Ref. Junct. Out :
Batt. Low Ramcard :
Calys 1200
Alarm status
Calibr. data : NONE
Ref. Junct. In :
Ref. Junct. Out :
Batt. Low Ramcard :
Calys 1500
Ram status
Two different pages are available according to the type of instrument
Ram status
Tcx/Rtdx data
: NONE
Calibr. Procedure data : NONE
Logging data
: NONE
Logging groups
: 0
Max logging data (100 %) : 1738
Calys
Calys
Calys
1000
Ram status
Ramcard status
: off
Ramcard size
: 128k
Tcx/Rtdx data
: NONE
Calibr. Procedure data : NONE
Logging data
: NONE
Logging groups
: 0
Max logging data (100 %) : 1738
1200
Ram status
Ramcard status
: off
Ramcard size
: 128k
Tcx/Rtdx data
: NONE
Calibr. Procedure data : NONE
Logging data
: NONE
Logging groups
: 0
Max logging data (100 %) : 1738
1500
The above data are self-explanatory and summarize the operative data/mode present into the instruments
H.7
General configuration set-up
This procedure allows the set-up of the general configuration of the instrument relevant to the parameter indicated below:
Date
(sets clock date -adjusts month/day/year according to the date format enabled)
Time
(sets clock time -adjusts hours/minutes/seconds)
Date fmt
(selects the date format "dmy" or "mdy")
Cnct fnct
(selects the external contact mode: none, hold, ons OUT, ons IN) ons=one-shot start/stop
Cnct state
(selects the external contact configuration: n.open (normally open) or n.closed (normally closed))
ID name
(sets the digital interface machine identification code from 1 to 99)
Baud
(selects the baud rate among the following: Off - 300 - 600 - 1200 - 2400 - 4800 - 9600 - 19200 - 38400 - 57600 - 115200)
Printer
(selects "enable" or "disable")
Aux Chn
(select the external sensor connected to the auxiliary connector among the following: none, humidity)
AmbT EU
(Set the engeneering unit for ambient temperature measured with the humidity/temperature external sensor)
Probe err
(sets the temperature remote sensor deviation from the actual one for higher accurate temperature measurements)
Avg weight S
(sets the Average weight value from 1 to 255 for electrical inputs)
Avg weight P
(sets the Average weight value from 1 to 255 for pressure inputs)
STO/RCL mode
(selects store and recalls operations simultaneously for single and multiple channels)
58/91