1
Download SR87, CH33
Transcript
2. Adjust the parallelism with respect to the machine guide of the scale rear while measuring the scale rear with a dial gauge. Tighten the set screws. <Measurement method> Measure near the installation hole positions at the scale unit rear. Fig. 10 0.1 MG Unit: mm 3. Insert the supplied spacer (t = 1.0 mm) in the space between the scale and slider, and then adjust the slider position while bringing the slider into contact with the scale. Fig. 11 Spacer (t = 1.0 mm) SR87, CH33 (E) 7
