Download HAA2850 - Velleman
Transcript
HAA2850 5. Overview and use Refer to the illustrations on page 2 of this manual. A B C D front red LED: lights up when output 2 is activated. amber LED: status indicator, synchronized with internal buzzer. green LED: lights up when output 1 is activated. keypad screw (2x) interior tamper switch buzzer relay 1 relay 2 DAP (Direct Access to Programming) jumper N.C. TAMPER: a Normally closed (N.C) contact that opens when the keypad is removed from the housing. Use this N.C. terminal to notify an alarm system (not incl.). 5b INT. LOCK: inter-lock control output, an NPN-transistor open collector output. It is OFF under normal conditions and switches to ground (-) immediately for the first 5 seconds after keying in a valid user code to operate output 1. It will remain grounded (-) as long as the door positioning sensor [d] is open. Use this output to control (disable) the other keypad in an inter-lock system to prevent both doors opening at the same time. Note: an inter-lock system is a two-door system that prevents opening both doors at the same time. For security reasons, the first door must be closed before the second can be opened. 5c O/P INHIB. (OUTPUT 1 INHIBIT): a Normally Open (N.O.) input terminal. When grounded (-) both user code 1 and egress button can not activate output 1. Cross-wire it with the INT. LOCK terminal [b] in an inter-lock system. Note: an egress button is an extra pushbutton (not incl.) that can be installed near the door when desired. 5d DOOR SENS (DOOR POSITION SENSOR INPUT): connect an N.C door switch (not incl.) to this terminal to monitor the status of an access door. Options: auto re-lock: the system will automatically relock the door after a programmed time for output 1. door forced-open alarm: instant alarm when door is opened without valid user code or egress input [k]. 60s alarm that can be stopped with 1 2 3 4 5 5a v4 - 15.11.2013 4 ©Ve llema n nv