Download VP-700-E VP-710-E VP-720-E

Transcript
Changing the batteries
(VP-710, VP-720 only)
If the LED for continuity Rx (7) is not lit when
the test probes are short-circuited, the batteries must be changed.
•
•
•
•
•
Disconnect the voltage tester VP-710
(or VP-720) completely from the measuring circuit.
Using a screwdriver, unscrew the two
metal screws on the battery compartment until the battery compartment
cover can be removed.
NOTE: Do not unscrew the screws completely.
Remove used batteries.
Insert new batteries, type 1.5V IEC
LR03. Ensure that the polarity is correct.
Correctly insert battery compartment
cover and screw down.
If batteries have leaked, the instrument
must no longer be used and must be
tested by our factory service department before it can be used again.
Never attempt to dismantle a battery
cell! The electrolyte in the cell is
extremely alkaline and electroconductive. Risk of chemical burns! If electrolyte comes into contact with your
skin or clothing, these spots must be
rinsed immediately with water. If electrolyte gets into your eyes, rinse them
immediately with clean water and consult a doctor.
Please bear this in mind and also consider
our environment. Do not throw used batteries into the normal household waste, but
hand the batteries over to hazardous waste
facilities or hazardous waste collection centres.
Observe the currently valid regulations
concerning the return, recycling and
disposal of used batteries and accumulators.
21