Download Compound Mitre Saw

ENGLISH
7. Troubleshooting
•
•
•
•
•
To prevent overheating of the motor, clean it regularly with an air jet or vacuum-clean it to remove any
chips or dust that might reduce cooling.
Connect the saw to an earthed outlet protected by a slow-blow fuse rated at not less than 10 A.
If the motor does not start immediately, release the trigger/switch. Unplug the mains lead and check
that the saw blade runs freely. If it does, try starting the motor again.
If the motor stops when the saw is cutting: immediately release the trigger/switch and unplug the mains
lead. Free the blade from the workpiece. Try starting the motor again.
Check connections, overloading (several devices on the same circuit, floodlights, etc.), conductor area
at least 1.5 mm² up to a cable length of 7 metres and at least 2 mm² for a cable length of 7 to 15 metres.
The power cable must not be more than 15 metres long.
8.Waste management
When the time comes to dispose of the product, do so in accordance with local regulations.
If you are not sure what to do, ask your local authority.
9.Technical data
Motor
230 V AC, 50 Hz
Rated power
1200 W
DutyS1
No-load speed
5000 rpm
Carbide-tipped saw blade
Ø 210 × Ø 30 × 2.6 mm
Number of teeth24
Adjustable saw blade tilt (bevel cuts)
0–45° to the left
Adjustable mitre cutting
- 45°/0°/+ 45°
LpA (sound pressure level)
89.2 dB(A) K: 3dB
LwA (sound power level)
102.2 dB(A) K: 3dB
Table:
390 × 135 mm
Max. timber size at 90°
60 × 120 mm
Max. timber size at 45°
60 × 85 mm
Max. timber size at 2 × 45° (double mitre) 35 × 85 mm
10