Download Prompt Set Pool - Aqua

2. POOL SET-UP AND FILLING WITH WATER
After a suitable and carefully selected site for the pool has been determined,
proceed to set up the pool according to the following directions. CAUTION: It
needs 2 people (adult) to set up the pool and it will let you quickly use the pool
within 30 minutes.
A. If your pool system comes with a ground cloth, carefully unfold it and place over
your pre-selected pool set-up area. Make sure that the ground cloth is spread out flat
and evenly, with no visible wrinkles or bunching present.
B. Place the pool atop the ground cloth (if applicable) with the hose connections towards
the area you wish to place the filter pump. It is important to align the orientation of
your pool towards the outlet you will use to power your filter pump. Ensure that your
pump’s electrical cord can safely reach your chosen electrical outlet. Finally, make
sure that the drain valve opening is in an accommodating position for end of season
water drainage. CAUTION: DO NOT DRAG THE POOL, AS IT MAY TEAR THE
POOL OR CAUSE OTHER DAMAGE. We will not be held responsible for damage
caused to the pool due to mishandling or failure to follow these instructions.
C. Carefully unfold the pool, spreading out the sides and floor to make them as smooth
as possible. NOTE: For ease of set-up, it is preferable to set-up the pool on a warm,
sunny day. If time permits, expose the unrolled pool to direct sunlight for 1 hour or
more, so that the pool material will be more flexible during set-up.
D. Inflate the top ring, keeping it in the middle of the pool (the top ring must be kept
inside the circumference of the pool bottom.) VERY IMPORTANT: The top ring
should be filled to approx. 85% capacity only. DO NOT attempt to inflate the ring
past this point. Excessive inflation of the top ring can cause the ring to burst or cause
damage to the ring’s seams.
E. Insert the included plugs on the inside of the pool into both filter pump hose
connections and the drain valve connector.
7