Download 906120284 - Ed.1 - CA 43

Note :
If the value of Dt is not programmed (symbolised by three hyphens on the Dt programming),
the memorisation does not function and the MEM symbol is not displayed.
Each memorisation is dated. This date, recorded in HH MM, also corresponds to a particular
memory address. Thus, for each wave of MIN, MAX and AVG recordings there corresponds
3 separate addresses with the time of memorisation, the unit of the measurement and the
SMOOTH or PEAK function that may have been selected.
At each memorisation the MEM symbol flashes once and a beep is sounded.
If the measurement memory is full (1920 addresses), the MEM symbol flashes and
memorisation stops.
Automatic memorisation mode is stopped by pressingMIN MAX
for more than two
seconds. During memorisation, if the rotary switch or the measurement probe are handled,
the function is also stopped.
Notes :
The MIN, MAX and AVG values accessible in measurement mode for reading with the
button are not memorised. In fact, these values do not correspond to the
MIN MAX
time chosen, but to the total operating time of the recording mode since the first press on
Dt (see in MEASUREMENT MODE, min, max and average recording).
MIN MAX
READ MEASUREMENT MEMORY
Set the rotary switch to MR to read the different values in the memory ( MR is displayed on
the screen).
Automatically, the last memorisation appears, by date.
The colon (:) at the middle of the time display is continuously visible to show that the time
displayed is not the current time. (time and date).
For each memorisation (each memory address), the different symbols remind the user of all
the parameters of the measurement at the time of the memorisation.
Press MEM
display.
at any time to display the number of the memory address of the screen
You may :
- either, read all the contents of the measurement memory by scrolling the different
▼
memorisations by means of the
and
buttons;
- or, read only the memorisations that have triggered an alarm by pressing ALARM
beforehand.
▼
62