Download Cover P1 - Shopify

1ï
- The Adflo Respiratory System must not be used in fire hazard or explosive environments.
- If the user is obliged to work very hard, negative pressure could occur in the head top when
he breaths in. This can give a lower protection factor.
- The protection factor can be reduced if the equipment is used in environments where high
wind speeds occur.
- The protection factor can be reduced with facial hair under the face seal.
- The Adflo Respiratory System is intended for use in the temperature interval of -5°C to +55°C.
(At temperatures below +10°C, the air inside the helmet can be perceived as being cold.)
- Note that the breathing tube might make a loop and get caught up by something in the
surrounding area.
- None of the respiratory system filters can be connected directly to the head top.
- To determine the protection / class of the Adflo Respiratory System the user shall ensure
that the marking on the filter is not confused with markings on the filters relating to standards other than EN 12941:1998.
Caution: The face seal in this product contains components made from natural rubber latex
which may cause allergic reaction.
4. UNPACKING/ASSEMBLY
Check that correct number of components has been supplied, as in figure 1.
Check that the apparatus is complete, undamaged and correctly assembled, any damaged or
defective parts must be replaced before use.
- Install the automatic welding filter in the welding head top, using the instructions included
with the welding shield. NOTE! Always use inside and outside protection plates.
- Install the headband in the welding head top, and connect the face seal to the headband,
figure 4.
- Install the Adflo unit on the belt, figure 5.
- Connect the breathing tube between the welding head top and the Adflo unit, figure 6. Check
that the breathing tube is securely fastened.
Carefully observe the instructions that explain how the equipment is to be used, before taking
it into service.
All components must be installed/used in accordance with this manual if the equipment is to
offer the specified protection. If any component is missing, or if anything is not clear, contact
the supplier.
Markings on the battery package.
= Read the instructions before use.
= Contains Nickel Metal Hydride.
= Plastics materials can be re-cycled.
= Must not be disposed of in general waste, but should be disposed of
according to local regulations regarding waste material
5. BEFORE USE / FITTING
5.1 Battery charging, figure 7.
The battery charger is designed for fast charging of batteries with 6 to 12 cells with capacity
2,5 to 4,5 Ah. The battery has a charging contact, so that it can be charged when installed in
the Adflo unit, or separately.
8