Download MT450T MT450 - Maktec
Transcript
ENGLISH (Original instructions) Explanation of general view 1-1. Shoe 1-2. Shoe button 2-1. Shoe button 2-2. Shoe 3-1. Switch trigger 3-2. Lock button 4-1. Blade clamp sleeve 4-2. Fixed position 4-3. Released position 5-1. Blade 6-1. Blade clamp lever 7-1. Hex wrench 7-2. Screw 8-1. Screw 8-2. Pin 8-3. Blade clamp 8-4. Hole 8-5. Blade 9-1. Hex wrench 9-2. Insulation cover 11-1. Limit mark 12-1. Brush holder cap 12-2. Screwdriver SPECIFICATIONS Model MT450T Length of stroke 28 mm 28 mm 130 mm 130 mm Pipe Max. cutting capacities Wood MT450 255 mm 255 mm Strokes per minute (min-1) 0 - 2,800 0 - 2,800 Overall length 457 mm 457 mm Net weight 3.2 kg Safety class 3.1 kg /II • Due to our continuing program of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country. • Weight according to EPTA-Procedure 01/2003 ENE021-1 ENG900-1 Intended use The tool is intended for sawing wood, plastic, metal and building materials with a strong impact. It is suitable for straight and curved cutting. Vibration The vibration total value (tri-axial determined according to EN60745: Work mode : cutting wooden beams Vibration emission (ah,WB) : 22.0 m/s2 Uncertainty (K) : 2.0 m/s2 ENG901-1 ENG905-1 noise level sum) Work mode : cutting boards Vibration emission (ah,B) : 19.5 m/s2 Uncertainty (K) : 1.5 m/s2 ENF002-2 Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated and can, therefore, also be used from sockets without earth wire. Noise The typical A-weighted according to EN60745: vector • determined Model MT450T • Sound pressure level (LpA) : 87 dB (A) Sound power level (LWA) : 98 dB (A) Uncertainty (K) : 3 dB (A) • Model MT450 Sound pressure level (LpA) : 88 dB (A) Sound power level (LWA) : 99 dB (A) Uncertainty (K) : 3 dB (A) • Wear ear protection 3 The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another. The declared vibration emission value may also be used in a preliminary assessment of exposure. WARNING: The vibration emission during actual use of the power tool can differ from the declared emission value depending on the ways in which the tool is used. Be sure to identify safety measures to protect the operator that are based on an estimation of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time).