Download KeyMatic von Conrad_NEU

11. Radio remote control
The radio remote control has been developed specially to control the door lock actuator
”KeyMatic”. It transmits the control commands encoded with an code change process and thus
offers a very high protection against the theft of the code (”tapping” and subsequent transmission
of the radio signal by persons without authorisation for access).
Neither is it possible to make a copy of the radio remote control in the way that this is very easily
possible with a conventional key.
If the radio remote control is lost, no new cylinder lock or a new locking system is necessary.
It is sufficient to delete the lost radio remote control from the memory of the door lock actuator.
Do not fail to observe the instruction for handling the code change system in section
”14 Miscellaneous”.
There is a radio remote control within the scope of delivery of the door lock actuator. A total of
up to nine radio remote controls on the door lock actuator can be registered.
a) Inserting battery
• Open the battery compartment on the back of the remote control by pulling off the cover of
the battery compartment little to the right in the clockwise direction, e.g., using a coin.
• Remove the cover of the battery compartment. Insert a button cell of the type ”CR2016” with
the correct polarity (the plus pole of battery has to point outwards).
• Replace the battery compartment cover and lock it again by turning it to the left (anticlockwise
direction).
1 Closed
2 Open, the cover can be removed
3 Battery inserted (plus points outwards)
58