Download Multi-Tool - Clas Ohlson

ENGLISH
Changing accessories
1. First remove any accessory that might
already be in the tool. Undo the locking
screw by turning it anticlockwise using
the supplied allen key.
2. Fit the accessory onto the tool
attachment making sure that
the holes pass over the lugs.
3. Tighten the locking screw using the allen key.
Changing sanding sheets
The sanding sheets are attached with hook and loop fasteners. Remove the old sanding
sheet, brush off the hook and loop fabric on the sanding pad if necessary, and then attach
the new sanding sheet.
Operation
Starting the machine
1. Before connecting the machine to the power point, make sure that the ON/OFF switch
(A) is set to OFF.
2. Start the machine by sliding the ON/OFF switch to the ON position.
Speed selection
• The speed can be regulated using the speed selector (B).
• The choice of speed depends on the type of work being carried out and the type of
material being worked. Experiment until you find the best setting.
Cutting-off and sawing
• If you are using the plunge-cutter saw blade, make sure that there are no nails
or screws in the workpiece. Remove any nails and screws or use the segment saw
blade HSS instead.
• If you are cutting wall tiles, bear in mind that the tool will be subjected to hard wear
during prolonged use.
9