Download 1 - Aerne Menu
Transcript
ENGLISH 2 INTRODUCTION 1 BEFORE USING Thank you for choosing the DENON DHT-500SD Home Theater System. This remarkable component has been engineered to provide superb surround sound listening with home theater sources such as DVD, as well as providing outstanding high fidelity reproduction of your favorite music sources. As this product is provided with an immense array of features, we recommend that before you begin hookup and operation that you review the contents of this manual before proceeding. TABLE OF CONTENTS z x c v b n m , . ⁄0 Before Using........................................................3 Cautions on Installation........................................3 Cautions on Handling.......................................3, 4 Features ...............................................................5 Discs ....................................................................5 Cautions on Handling Discs.................................6 Connections ...................................................6~ 9 Part Names and Functions ............................9~12 Remote Control Unit ...................................12~15 Setting up the System ................................16~20 ⁄1 ⁄2 ⁄3 ⁄4 ⁄5 ⁄6 ⁄7 ⁄8 ⁄9 ¤0 Basic Operation ...........................................21, 22 Surround Mode............................................23, 24 Playback.......................................................24~26 On-Screen Display .............................................26 Using the On-Screen Display.............................27 Special playback...........................................28, 29 Changing the Default Settings (DVD)..........30~32 Listening to the Radio .................................32~34 Troubleshooting .................................................34 Specifications.....................................................35 2 ACCESSORIES 2 ADV-500SD (DVD Surround Receiver) Check that the following parts are included in addition to the main unit: q Operating instructions ..........1 r R6P/AA batteries ..................2 y FM indoor antenna ..............1 e r / VCR AV FUNCTI ON - TUNER - VCR VCR A-B REPEAT VIDEO t y u 2 TUNING TV VOL / RT CH ++ ERER ENTENT R MME E/DI TON SUB SUB TITLE TITLE CH TOP TOP MENU MENU PBC + DD OUNOUNTERTER MEME SURRSURRAMEAME PARARAPARARA RC-9 73 VCR 2 SYS-500SD (speaker system) Before using, check that the package contains the main speaker units (SC-A500SD x 4 units, SCC500SD x 1 unit, DSW-500SD x 1 unit) and the accessories shown below. q Speaker cord A ..........................................2 (Used to connect the SC-A500SD) Length: Approx. 10 meters w Speaker cord B ..........................................4 (Used to connect the SC-A500SD, SC-C500SD and DSW-500SD) Length: Approx. 3 meters e Anti-Slip pad (4 pcs / 1 sheet) ....................5 q 2 CAUTIONS ON INSTALLATION Noise or disturbance of the picture may be generated if this unit or any other electronic equipment using microprocessors is used near a tuner or TV. If this happens, take the following steps: • Install this unit as far as possible from the tuner or TV. • Set the antenna wires from the tuner or TV away from this unit’s power cord and input/output connection cords. • Noise or disturbance tends to occur particularly when using indoor antennas or 300 Ω/ohms feeder wires. We recommend using outdoor antennas and 75 Ω/ohms coaxial cables. For heat dispersal, leave at least 10 cm of space between the top, back and sides of this unit and the wall or other components. TV TV PWR PWR ZOOM TV ZOOM TV CH CH AMP - MENU MENU • Note that the illustrations in this instructions may differ from the actual set for explanation purposes. 10 cm or more BAND ON/STAND FUNCTION SURROUND MODE MEMORY PROGRESSIVE SCAN TUNING MASTER VOLUME /SELECT TITLE STANDBY PHONES FM MODE TONE/DIMMER DVD SURROUND RECEIVER ADV-500SD CHP DVD P.SCAN D EX 10 cm or more ON TV TV IN IN MUTIN G SELECT DISPLA DISPLA YY AUDIO AUDIO - STATUS SETUP CH RETURN RETURN ANGLE ANGLE • Before turning the power switch on Check once again that all connections are proper and that there are not problems with the connection cords. Always set the power switch to the standby position before connecting and disconnecting connection cords. • Store this instructions in a safe place. After reading, store this instructions along with the warranty in a safe place. NTSC/P PWR AL PWR TV PTY TV CH CH RANDO BAND BAND M CT ++ SURRO UND TV 1 ++ 99 +10 MODE 33 ++ INPUT DVD TUNER VIDEO 22 66 88 00/10/10 TONE PROG/D MODE IRECT MODE RDS TV REPEAT MEMO MEMO TUNER -- 55 CALL CALL TEST AA//VV DVD e Remote control unit (RC-973)............…...........1 • Moving the set To prevent short circuits or damaged wires in the connection cords, always unplug the power cord and disconnect the connection cords between all other audio components when moving the set. OFF SLEEP CLEAR 11 44 77 DVD w Service station list ..............1 t AM loop antenna ................1 u Video cord ..........................1 Pay attention to the following before using this unit: w e Wall 3 CAUTIONS ON HANDLING • Switching the input function when input jacks are not connected A clicking noise may be produced if the input function is switched when nothing is connected to the input jacks. If this happens, either turn down the MASTER VOLUME control or connect components to the input jacks. • Whenever the power switch is in the STANDBY state, the apparatus is still connected on AC line voltage. Please be sure to unplug the cord when you leave home for, say, a vacation. • Muting of PRE OUT jacks, HEADPHONE jack and SPEAKER terminals The PRE OUT jacks, HEADPHONE jacks and SPEAKER terminals include a muting circuit. Because of this, the output signals are greatly reduced for several seconds after the power switch is turned on or input function, surround mode or any other-set-up is changed. If the volume is turned up during this time, the output will be very high after the muting circuit stops functioning. Always wait until the muting circuit turns off before adjusting the volume. 3