Download Swiss SA

Manual instruction
The table shows recommended times for different
types of material.
MATERIAL
EN
SECONDS
Plastic & latex paint
24-28
Water based paint
20-25
Primers
24-28
Varnishes
20-25
Oil based paints
18-22
Enamel paints
18-22
Aluminum paints
22-25
Car undersealing
25-35
Wood sealers
fig.2
2
28-35
Wood preservatives
No thinning required
Wood stains
No thinning required
If the paint takes longer than the recommended time
to empty, then further thinning is required. Mix in a
small quantity of the appropriate thinner and use the
viscosity test until the correct thickness is achieved.
Some spray able materials contain particles and
lumps. These materials should be strained before
filling the paint container.
Switching on and off
Before connecting the device to the electric power
supply, make sure that the main supply voltage
is 230V/50Hz and being suitable for use only in
premises having a service current capacity equal
to or greater than 100A per phase with a normal
voltage of 400/230V.
Always use the correct supply voltage: the power
supply voltage must match the information quoted
on the tool identification plate.
A poor spray pattern will concentrate the paint in
the centre of the spray and give a blotchy finish.
A good spray pattern will give even distribution of
paint throughout the pattern.
Switching off
• Release the on/off switch (3) to stop the spray gun.
ATTENTION! Immediately switch off the spray gun
when:
• interruption in the mains plug, mains lead or
mains lead damage.
• defect in the ON/OFF switch (3).
• there is smoke or stench of scorched isolation.
Spraying techniques
• To obtain the best results, keep your spray gun
level and parallel to the surface at all times.
• Keep the nozzle 25 - 30 cm from the surface and
spray evenly from side to side or up and down (fig.3-4).
fig.3
250~300
mm
Switching on
1. Fill the paint cup (5) with the correctly thinned
and strained paint.
2. Connect the spray gun to the mains supply.
3. Aim the spray gun at a piece of scrap material
and operate the on/off switch (3) until paint is
spraying.
Operating instructions
• Adjust the fluid adjustment knob (2) until the
required volume of paint is spraying.
Adjustment of the fluid adjustment knob (2) will
affect the spray pattern. Turn the fluid adjustment
knob in a clockwise direction to reduce the flow and
anti-clockwise to increase the flow (fig.2).
12