1
Download Manuel
Transcript
ENGLISH and the motor runs at the speed set with the jumper. In the remaining 60 seconds the motor will only start after a signal from the PIR module, at the speed set with the jumper; when there is no signal from the PIR module, the motor will stop immediately (time lag for switching off = 0). At the end of the "Test Mode" phase, the appliance will go into normal operation. Table B Speed V1 Position A MIN speed Jumper Position B MAX speed Wiring diagrams Fig. 21 ÷ 25 Maintenance and cleaning Fig. 26 ÷ 28 57
