Download 125 MAX

Operating Instructions FR 125 MAX, FR 125 Junior MAX and FR 125 Mini MAX
3. Verification or replenishing of oil level in gear compartment
The gear compartment will have already been filled with the appropriate amount of oil by the
engine manufacturer. However before engine installation in frame, the oil level must be verified or
replenished.
Î
Place engine on a horizontal surface (without engine pedestal).
„ Attention: When placing the engine on a horizontal surface, take care not to damage the
electric starter connection.
Î
Remove the Allen screw (1) and sealing ring (fig. 3). If no oil emerges through the
tapped hole, remove the venting screw (3) and slowly fill in oil of specification SAE
15W40 until oil emerges at oil level checking screw (1). (Filling capacity on new
engine is 0,05 l / 1,7 fl OZ (US).
Fig. 3
Î
Fit Allen screw (1), and sealing ring, tighten to 10 Nm.
Î
Fit venting screw (3) hand tight.
¡ Note:
By removing the Allen screw (2) the oil can be drained from the gear compartment.
Seite/page 58/104
Ausgabe/edition 02/2006