Download EM 7240

Type of weight
Weight application position
Traditional clip
Always H 12
Adhesive
H3
Adhesive
H6
Adhesive
H12
The positions on the wheel of H 3, H 6 and H 12 are shown in Figure 11c.
11c
BALANCING PROGRAMMES
Before starting a balancing operation, the following steps must be followed:
-Fit the wheel on the hub using the most suitable flange;
-Lock the wheel so that no movement is possible during the wheel spin and braking
phases;
-Remove any counterweight, pebble, dirt or other foreign body;
-Set the wheel's geometric data correctly.
UK
Dynamic balancing (standard)
Proceed as follows to balance a wheel in dynamic mode:
-Press the
illuminates.
and keys until the LED corresponding to the DYN programme
-Press the key
to confirm the selection.
This programme is automatically launched when the machine is switched on.
-Set the wheel's geometric data.
-Spin the wheel by lowering the guard.
To obtain the most accurate results, do not apply any undue stress to the machine
EM 7240 Operator’s manual
79