Download manuale PLUS 9

5 . ) # !4 % 2 ENG
4.0
LIST OF ALARMS
The stove control system is equipped with various safety devices to constantly make sure it is running
correctly; the following alarms may appear on the screen:
Description on the
screen
Alarm meaning
No air in the combustion
chamber
No depression
Possible cause
Suction/Unloading circuit
blockage or open door
The smoke extraction engine The smoke extraction engine
is not running
is broken or stuck
Electricity black out or the
No electric power during
plug is not connected to the
operation
mains
Excessive pellet loading,
Smoke discharge
ventilation is not running,
temperature is too high
smoke exchanger needs to
be cleaned
No ejection
No electricity
High smoke
temperature
Flame interruption
Shutdown due to too low
smoke temperature
Thermocouple (TC) is
broken
Smoke thermocouple is
broken
Start failed
The stove did not start
automatically
Allarme sensor
Stop working
Service
La stufa ha raggiunto le ore
lavorative programmate
4.1
Check that there are no
obstructions on the suction pipe
Make sure the door is well
closed
Contact your local CAT
Check that the power cord is well
plugged in and the power switch
is in the ON position
Contact your local CAT for a
general clearing of the stove
Check whether the tank there
No pellets, flame is too low at
are pellets
idle
Contact your local CAT
Wear and tear of the
Contact your local CAT
component
Load pellets into the cochlea
Start with empty auger or
(see section 2.0 of the manual
with dirty crucible
control unit)
Clean the crucible
Contact your local CAT
Sensor fault
Contact your local CAT for a
Raggiungimento ore
general cleaning of the stove and
lavorative di set
zero setting hours
RESET BUTTON
In case of overheating of the heater due to failure or
obstruction of the ventilation system, intervenes a safety
thermostat with manual reset that blocks the supply of
pellets.
Before carrying out any operation, turn off the stove and
remove the power outlet; once the stove has cooled, you
should act to solve the problem.
To reactivate the features of the stove just do the following:
- Unscrew the protective cap;
- Press the red reset button;
- Screw the protective cap;
- Do you turn the stove
36
Operation to do