Download BHP459

ENGLISH (Original instructions)
Explanation of general view
1
2
3
4
5
6
7
Red indicator
Button
Battery cartridge
Star marking
Switch trigger
Lamp
Reversing switch lever
8
9
10
11
12
13
14
Speed change lever
Action mode changing ring
Adjusting ring
Graduation
Arrow
Sleeve
Groove
15
16
17
18
19
20
Hook
Screw
Bit holder
Bit
Vent
Blow-out bulb
SPECIFICATIONS
Model
Capacities
No load speed (min–1)
Blows per minute
BHP459
Concrete
13 mm
Steel
13 mm
Wood
38 mm
Wood screw
6 mm x 75 mm
Machine screw
M6
High (2)
0 – 1,500
Low (1)
0 – 400
High (2)
0 – 22,500
Low (1)
0 – 6,000
Overall length
192 mm
Rated voltage
D.C. 18 V
Battery cartridge
BL1815/BL1815N
BL1830
Net weight
1.5 kg
1.7 kg
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from
country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
ENE079-1
Intended use
The tool is intended for impact drilling in brick, concrete
and stone. It is also suitable for screw driving and drilling
without impact in wood, metal, ceramic and plastic.
GEA010-1
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.
GEB056-5
CORDLESS HAMMER DRIVER DRILL SAFETY
WARNINGS
1.
2.
3.
4.
5.
6.
7.
8.
4
Wear ear protectors when impact drilling. Exposure to noise can cause hearing loss.
Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring. Cutting
accessory contacting a “live” wire may make
exposed metal parts of the power tool “live” and
could give the operator an electric shock.
Hold power tool by insulated gripping surfaces,
when performing an operation where the fastener may contact hidden wiring. Fasteners contacting a “live” wire may make exposed metal parts
of the power tool “live” and could give the operator
an electric shock.
Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
Hold the tool firmly.
Keep hands away from rotating parts.
Do not leave the tool running. Operate the tool
only when hand-held.