Download Schnittstellen

Operating Instructions
Interfaces
Chapter 15
OLV
15.3
Communication via RS-485 or RS-422
The following data can be transmitted via the RS-485 or RS-422 interface:
•
Measured values
•
Diagnostic data
•
Parameters
The following settings apply to the interface:
Tab. 28: Configuration of
RS-485 or RS-422 interface
Value
Factory setting
Configurable
Possible values
Data
transmission
rate
115200 baud
Yes
2400, 4800, 9600, 19200, 3800,
57600, 115200, 230400, 460800
Data bits
8
No
Parity
None
No
Stop bits
1
No
Separator
<CR><LF>
Yes
<CR> / <CR><LF>
The data transmission rate and separators can be modified in the OLV Config Tool
(see Chapter 15.4, Page 53).
The output of measured values and diagnostic values can be activated via special
commands over the interface. Output can be configured on request or continuously.
8015443/YI31/2015-01-25
© SICK AG • Subject to change without notice
51