Download english - Reloop

Jog wheel effect modulation:
It is also possible to modulate the effect parameters via the jog wheel -18 H-.
Select the desired effect and switch the FX/Reverse mode -21 S- to effect 1 or
effect 2.
NOTE!
In order to change the FX/Reverse mode via controller push and hold the
shift button -23 H- and push FX/Reverse -21 H-.
Depending on the selected effect you can now steplessly adjust the ratio
parameter via the jog wheel -18 H-. In order to steplessly modulate the time
parameter hold shift -23 H- and turn the jog wheel -18 H-.
NOTE!
If the FX/Reverse slot has been adjusted to effect 1 or 2 -21 S- it is possible
to (de-)activate the effect via the FX/Reverse button 21 H-.
3.9. Sample, loop & cue point section
3.9.1. Cue points
There are to possibilities to set a cue point:
b) The second possibility is to search a frame via the jog wheel while in pause
mode. Go to the desired point, push play -6 H / S- and the cue point is set.
NOTE!
This is also works if scratch mode is enabled.
If you would like to save a cue point push the “save to” button -26 H / S- and a
respective sample cue bank -27 H / S-. This way the cue point is saved
permanently until you set a new one, thus overwriting the old one.
3.9.2. Loops
Manual loop:
In order to set a loop manually push the loop in button -24 H / S- at the desired
point and at the end of the loop push the loop out button -24 H / S-. Now the
player switches to the seamless loop function. Exit the loop by pushing the loop
out button -24 H / S-.
ENGLISH
a) The first one is to push the loop in button -24 H- during playback. This way a
cue point is set at the push of a button and it is displayed by a “C” in the
needle view.
NOTE!
By pushing the loop out/reloop button -24 H- during playback mode the
player will return to the last set loop.
Auto loop:
If the BPM value of a track has been analyzed an automatic beat loop can be set
at the push of a button. To do so push the beat tact button -25 H / S- and the
player will switch to loop mode. The adjusted bar length is visible next to the beat
tact button ( – 8/1). In order to change the bar length either click the bar via
mouse in the software or push the beat tact button -25 H- directly on your
controller. In order to exit the loop push the loop out button -24H / S-.
51