Download E-Roller UCARVER

Unfolding the steering column
The UCARVER is delivered folded.
Possible clamping lever position when delivered
(locking mechanism see Diag.5, arrow).
Press the black button on the handlebar stem (see Diag.6, arrow). This will
unlock the steering column and allow it to be folded upwards.
Diag.5
Diag.6
Fold the steering column upwards with one hand, and
secure it in place with the other (see Diag.7). Listen to
make sure that the locking mechanism (clamping lever and
safety button) "clicks" properly into place.
click into place
Diag.7
Charging using the mains adapter
! Only charge the battery via the charging socket at the rear, using the enclosed charger, connected to a
suitable mains socket (220-240V~).
! Before plugging in the charger, make sure that the e-scooter is switched off and that it cannot roll away.
! Take all usual precautions required when dealing with electricity.
! Never touch, short circuit or submerge electronic parts, and never spray water
underneath the rear wheel casing.
! Always charge the battery under supervision and do not leave the charger plugged in
any longer than necessary once the battery is fully charged.
! Begin by plugging the mini-plug of the charger into the
socket on the
e-scooter.
! Then plug the mains plug of the charger into the power socket. The charging
LED lights up red on the mains adapter while charging is in progress.
! Once the UCARVER has finished charging (charging LED lights up green), pull
out the mains plug, then remove the mini-plug from the UCARVER. Always
make sure that the mini-plug is pulled out before riding off, to avoid any
damage.
! Store and use the mains adapter inside, in a dry place and at room temperature.
Mini-plug
Instructions for Use / Created: GW St. Pölten
Edition: 2014-09-09
Page 7 of 24