Download AQUARAY

AquaRay MultiControl instructions v1-2010_Layout 1 11/06
Operation
Once mounted and connected according to the
installation instructions above, the PSU may be
switched on. The screen will display ‘PLS WAIT’
while it initialises. Once it has entered ‘RUN’
mode (i.e. the clock is displayed) you may
program the unit as detailed below:• Pressing the MODE button will cycle through
the available modes (see table overleaf). If no
button is pressed for 10 seconds, the AquaRay
MultiControl unit will return to ‘RUN’ mode.
• Holding a button down will cause an auto-repeat
of that button.
• Pressing ‘+’ in ‘RUN’ mode will advance
Channel 1 to the next phase. The phases are;
OFF, RAMP UP, ON and RAMP DOWN.
• Pressing ‘-’ in ‘RUN’ mode will initiate the
‘Storm Function’ (see later in this booklet for
details of this function). Pressing ‘-’ whilst in
‘Storm Function’ will exit and resume the user
set program.
• Lamps start to brighten when the ON TIME
equals the current time. A RAMP time of 1 is
equivalent to 1 minute before lamps are at full
brightness.
3