Download PN-L702B - Sharp Australia Support

Supplied Components
If any component should be missing, please contact your dealer.
 Touch pen: 1
 Pen tip (for touch pen): 2
 Touch pen battery
(LR-03 (“AAA” size)): 1
 USB cable: 1
 Eraser: 1
 Tray: 1
 Tray mounting fitting (cover / bracket): x 2
 Tray mounting screws: M5 x 4 / M4 x 2
 Terminal label: 1
Used when installing the interface
expansion board PN-ZB01 (optional).
 Cover Sharp logo: 1
Place this sticker onto the SHARP logo to
cover the logo.
ENGLISH
 Liquid Crystal Display Monitor: 1
 Remote control unit: 1
 Cable clamp: 2
 Power cord: 1
 R-6 battery (“AA” size): 2
 CD-ROM (Utility Disk for Windows): 1
 Setup Manual (this manual) : 1
* Sharp Corporation holds authorship rights to the Utility Disk program. Do not reproduce it without permission.
* For environmental protection!
Do not dispose of batteries in household waste. Follow the disposal instructions for your area.
Preparing the Remote Control Unit and the Touch Pen
Installing the batteries
Inserting the battery
1. Press the cover gently and slide it in the direction of the
arrow.
1. Rotate the battery cap and remove it, and then pull out the
cover.
Battery cap
2. See the instructions in the compartment and put in the
supplied batteries (R-6 (“AA” size) x 2) with their plus (+)
and minus (-) sides oriented correctly.
3. Close the cover.
2. Insert the supplied battery (LR-03 (“AAA” size)) in the
orientation shown, and attach the cover and battery cap.
5
E