Download ContiPressureCheck™

Installation
5.8
Retreading
Ŷ After retreading, install the tire sensor in a new container, see Chapter 5.4.8 Installing the sensors in the
rubber container and install in the tire.
GB
NOTE
Ź If no bladder is used during the retreading process and the process temperature
is below 100 °C (212 °F), the tire sensor
can remain in the tire.
5.8.1
Instructions for tire fitting
NOTE
Ź In order to be able to better identify the
position of the tire sensor from the outside after fitting the tire, position the tire
sensor bonded into the tire in the area of
the DOT stamp close to the valve seat.
Ź When fitting the tire using tools such as
tire levers, ensure that these do not damage the tire sensor.
5.9
Continued use of the tire sensor after changing a tire
If continuing to use the tire sensor after changing a tire, pay
attention to the indicated battery service life and the running life of the sensor indicated in Chapter 3.1 Technical
data - Tire sensor.
127
USA
Ŷ Before retreading the tire, remove the tire sensor. The
rubber container can remain in the tire.
CPC