Download MAIA 01

Lampada dentale MAIA
INSTRUCTIONS FOR USE
SWITCHES SYMBOL
ON-OFF
“MAIA” LAMP WITH SWITCH (see description of the parts)
On/Off/Adjustment
- To turn the lamp on and off, press and release the command lever on the left or right. When
the command is given, an acoustic signal will be heard (1 beep).
- Adjustment: The lamp turns on at the maximum level of illumination. To reduce the light
intensity, hold the command lever pressed on the left/right side until it reaches the
desired level of intensity. The command does not allow the user to increase the light
intensity. When the lowest level of intensity is reached, an acoustic signal will be heard
(1 beep).
- Luminosity can only be regulated from the maximum to the minimum level
- To return to maximum intensity, switch the lamp off and then on again.
The control lever must be managed very carefully to avoid breakage.
Each time that the lamp is turned on, the light intensity is at the maximum
level.
progeCAD 2008 Smart! - Private use only
“MAIA” LAMP WITH PROXIMITY SWITCH (see description of the parts)
On/Off
- To turn the lamp on and off, place your hand close to the sensor, within a maximum
distance of 3 cm. When the command is given, an acoustic signal will be heard (1 beep).
- To adjust the light intensity, remain with your hand near the sensor until the desired level
of intensity is reached, from the highestto the lowest settings.
- Luminosity can only be regulated from the maximum to the minimum level
- To return to maximum intensity, switch the lamp off and then on again.
“MAIA” LAMP WITH REMOTE CONTROL DEVICE (see description of the parts)
Remote cable length 4 m – Maximum range from arm on the side of the pin: 2.5 m.
The remote cable must not be lengthened during installation. Any operation
done on the remote cable could produce negative effects on the “EMC”
performance.
On/Off/Adjustment
- To turn the lamp on and off, press and release button “A”.
- Adjustment:
a) to reduce the light intensity, keep button “A” pressed until the desired level of
intensity is reached. When the minimum level of intensity is reached, an acoustic
signal will be heard (1 beep).
- Luminosity can only be regulated from the maximum to the minimum level
- To return to maximum intensity, switch the lamp off and then on again.
A
B
20
BUTTON B IS NOT ENABLED.