Download Operating Instructions

TYROLIT Hydrostress AG
4.8
Switching off the wall saw
Switching off the wall saw
Proceed as follows:
XX Press the start switch (1) on the remote controller to the 0 position.
XX Turn off the cooling water, switch (2) water 0/1.
XX Switch off the wall saw WSE811 using the main switch (3).
XX Switch off the WSE811 wall saw using the main switch on the wall saw head.
Caution
Frost can damage the wall saw WSE811!
XX Blow out any water if there is a risk of frost (see chapter 4.9, Blowing out the water).
Only stop the wall saw WSE811 using the EMERGENCY STOP function in an emergency.
4.9
Blowing out the water
99 The main switch is set to OFF
XX Disconnect the mains plug.
XX Disconnect all water lines.
XX Connect the purge pump to the water nipple.
XX Blow out water until all of the cooling water has been removed (see chapter 5.2).
XX Remove the pump.
Page 26
Wall saw WSE811