Download USER MANUAL

Table - 04
Problems
* Irregular cut.
* The disc stops during the
operation
Causes
* Edgeless disc blades.
* Lack of electricity on the
machine
* Problem on the internal or
external electric circuit of the
machine
* Burnt smell or smoke
* Disc not properly positioned
* Faulty ball bearings
* Disc Chamber leak
12
Summary
* Do the sharpening of blades
as indicated on item 5.2.1
(Blades Sharpening)
1. Introduction
02
* Check if the plug is
connected to the power point
and if there is Electricity.
1.1
1.2
1.3
1.4
02
02
04
04
Safety
Main Components
Technical Characteristics
Available Disc
* Call Technical Assistance.
* Problem on the electric motor
* Call Technical Assistance.
or other electrical part
* The machine turns on but the * Faulty motor start capacitor
disc takes too long to start
spinning
*Skidding belts
* Strange noises.
Solution
* Call Technical Assistance.
* Call Technical Assistance.
* Remove the Disc
Chamber and place it
properly.
* Call Technical Assistance.
* Disc chamber not properly
attached
* Tighten the Maniples
Nº.07 (Pic.01)
* The maniples Nº.07 (Pic.01)
are loose
* Tighten the Maniples
Nº.07 (Pic.01)
* Dirt accumulation between
the base Nº.10 (Pic.01) and the
Disc Chamber Nº.02 (Pic.01)
* Do the cleaning, as
indicated on item 3.4, page
07.
2. Installation and Pre Operation
04
2.1 Installation
2.2 Pre Operation
04
05
3. Operation
05
3.1
3.2
3.3
3.4
05
06
06
07
Activation
Disc Placement
Feeding Procedure
Cleaning
4. General Safety Rules
08
4.1
4.2
4.3
4.4
4.5
4.6
4.7
08
09
10
10
10
11
11
Basic Operation Procedures
Safey Procedures and Notes Before Switching the Machine On
Routine Inspection
Operation
After Finishing the Task
Maintenace Operation
Warnings
5. Problemas Analysis and Solutions
11
5.1 Problems, Causes e Solutions
5.2 Adjustment and Components Replacement
5.3 Electric Diagram Mod. PA-7L PIZZA
11
13
13
01